About Titan Shield
We keep premium surfaces looking the way they did on the day they were installed.

Titan Shield is an interior surface protection business in Bengaluru, Karnataka. We install clear protective film on marble, stone, glass, wood and stainless steel in homes and businesses.
Why we do this
Marble, glass and polished steel are chosen because they're beautiful, and they're easy to damage. One lemon spill or one busy week can leave a mark that polishing won't fully remove.
We started Titan Shield so that people can use these surfaces without worrying about them. You enjoy the table you chose, and the film takes the daily wear.
What the film is
The film is a thin, clear layer fitted directly onto a finished surface. Once installed, it sits between your stone, glass or steel and everything that touches it.
Spills, scratches and fingerprints land on the film and not on the surface. If the film eventually wears, it can be replaced while the surface below stays as it was.
Our four-step process
- 1
Assessment
We check the material, its condition and how the surface is used. You see the gloss and matte films on your own surface and get a clear quotation before anything begins.
- 2
Surface prep
Dust, grease and old polish are removed, and the edges are checked. Good preparation is what makes the film look invisible afterwards.
- 3
Precision installation
Our installers fit the film around corners, sinks and cut-outs, and press out air and moisture as they go. Commercial sites can be scheduled around business hours.
- 4
Quality check
We check the finish in natural and artificial light, walk through it with you and leave simple care instructions along with your warranty details.
Inside an installation
Every job follows the same careful steps, from measuring the surface to the final inspection.
Illustrative images, not photos of customer jobs.


1. Measure the surface

2. Cut the film to size

3. Clean the surface

4. Check for dust

5. Mist the surface

6. Lay the film

7. Squeegee it flat

8. Trim the edge

9. Cut around the sink

10. Shape rounded edges

11. Seal the edges

12. Inspect the finish
Why Titan Shield

Invisible finish
The colour, veining and shine of your surface stay exactly as they were.
Stain and scratch protection
Spills wipe off the film, and daily knocks mark the film rather than the stone.
Heat resistance
Hot plates and serving dishes are far less likely to leave a mark.
Clean removal, no residue
The film can be taken off later without damaging the surface underneath.
Trained installers
Our team cuts each piece to the surface and seals the edges by hand.
Warranty-backed
Every installation is covered by a written warranty.

Let's look at your surface.
Just your name and mobile number. It takes less than a minute.
